TGMC:Guide to engineering

Эта страница относится к TGMC. TGMC это билд, созданный на основе CM-SS13 и переделанный под ТГ.

Инструмент:	Использование:
Screwdriver	Отвертка разворачивает турели, открывает панели на дверях и автоматах.
Blowtorch	Сварка прорезает стены, ремонтирует поврежденные турели, баррикады, ББП. Очищает вульп.
Crowbar	Used for Opening unpowered doors and displacing girders so you can move them.
Wirecutters	Кусачки. Режет провода.
Wrench	Гаечный ключ используется для закрепления и открепления многих вещей.
Multi Tool	Мультитул используется для проверки проводов при взломе и обезвреживания мин.
Cable Coil	Катушка кабеля используется при прокладке проводки и для ремонта ожогов на конечностях роботов.
Insulated Gloves	Изоляционные перчатки для защиты от электричества во время доступа к электронике.
Light Replacer	Заменитель ламп быстро заменяет разбитые лампы, перезаряжается стеклом.
T-Ray Scanner	Сканер коммуникаций отображает вентиляционные отверстия, трубы и проводку под напольным покрытием.
Welding Goggles	Сварочные очки предотвращает выгорания глаз при ярком свете, например при сварочных работах.

Энергосистема

Корабельные термоядерные и геотермальные реакторы

Корабельный термоядерный реактор будут запускаться в идеальном состоянии и предварительно загружен термоядерной ячейкой в ​​начале каждой миссии, что упрощает их включение. Однако планетарные геотермальные реакторы всегда будут в максимально плохом состоянии. Если вам необходимо отремонтировать или в случае корабельного реактора, заменить термоядерную ячейку на новую, вот простые шаги, как это сделать.

• Первый шаг: сначала оцените ущерб. Если реактор не поврежден, переходите ко второму шагу.
  • Если реактор выглядит так /, воспользуйтесь сваркой, чтобы отремонтировать его до следующего уровня повреждений.
  • Если реактор выглядит так /, воспользуйтесь кусачками, чтобы отремонтировать его до следующего уровня повреждения.
  • Если реактор выглядит так /, воспользуйтесь гаечным ключом, чтобы восстановить его до идеального состояния.
• Второй шаг: оцените уровень мощности (это относится только к термоядерным реакторам, если реактор, который вы ремонтируете, является геотермальным, перейдите к третьему шагу). Это можно выяснить двумя способами: первый – исследовать (examain) реактор и получить процентные показатели, а второй - искать ярко-синюю полосу на правой стороне реактора, которая дает приблизительные значения. Если реактор включен, центральный экран будет мигать и становиться красным, когда батарея разряжена.
  • Если мощности мало и она на исходе, сначала выключите реактор, если он работает, щелкнув по нему пустой рукой.
  • Затем ломом откройте панель обслуживания, и аккумуляторупадет на землю под вами.
  • После этого возьмите свежую ячейкус одного из столов на северной или южной стороне и отнесите разряженную ячейку в recycler справа, для её перезарядки на будущее.
• Третий шаг: Наконец, включите реактор. Если вы все сделали правильно, то он должен заработать. Если нет, пересмотрите каждый шаг. Если он по-прежнему не включается, подумайте о том, чтобы обратиться за помощью к опытным инженерам.

APCs and the Bench Test of Robust Engineers

Файл:DMCA Engineer.png

The Only Engineer говорит: «Uhh . . . SL! I don't know how to repair the APC!»

The Livid Squad Leader говорит: «WHAT THE FUCK YOU MEAN YOU DON'T KNOW HOW TO REPAIR THE APC?! DON'T THEY TEACH YOU THAT IN MCES (Marine Corps Engineer School)?! NEVER MIND, JUST READ THE FUCKING MANUAL, YOU DAMN USELESS SON OF A BITCH!! YOU THINK YOU JUST BUILDING BARRICADES, DIGGING UP SANDBAGS, WRENCH FUCKING SENTRIES, AND BUTT FUCKING HSG WITHOUT HAVING TO FIX APCS?! GOD DAMN, WANT ME TO YELL AT YOU HOW PATHETIC YOU ARE AGAIN?!»

Repairing Broken APC

If its wires are simply cut (such as from a xeno swipe), simply use the wire cutters and mend every wire and replace the panel with a screwdriver.

Repairing Completely Destroyed APC

If it was totally destroyed, it is time to really knuckle down and unga the utter heck out of this APC.

• Remove the cover with a crowbar or whack it off with something, like a knife.
• Remove the power cell with an empty hand.
• Screwdriver the board loose.
• Crowbar the board out (boards from destroyed APCs crumble when removed, necessitating a replacement).
• Expose the power terminal by crowbar the floor tile in front of the APC
• Use wirecutters to remove the power terminal, you will receive 5 cable coils from this.
• Use a blowtorch to weld the frame off the wall, you will gain 1 metal sheet from this.
• Construct a new APC frame from two sheets of metal.
• Hold the frame and attach it to the wall.
• Install a power control module.
• Screwdriver the board in place.
• Install 5 cable coil into the APC.
• Slot in a power cell.
• Crowbar the cover shot.
• Swipe the APC with an appropriate ID card and access the interface.
• Enable the breaker.
• (Optional) Lock the interface with the ID.

Replacing power cell

• Assuming the APC is undamaged, first unlock the APC if it is not already with an ID card with APC access.
• Access the interface and disable the cover lock.
• Crowbar open the cover.
• Remove the drained power cell (if there is one) with a free hand.
• Install a fresh power cell.
• Crowbar the cover closed.
• (Optional) Lock the APC with the ID. The cover lock will automatically engage.

SMES

SMES is short for Superconducting Magnetic Energy Storage, but most people just call them power storage units. They're effectively similar to power cells but scaled up to the industrial level and are designed to store power and transmit it across power cables to the APCs, which powers the doors, lights and most everything else.

The SMES on the ship, at the beginning of the round, are fully charged and already set to output enough power to operate every APC on the ship, but in the event they are not, simply set the input side to "Auto" and then "MAX". For the output, you'll want to set each SMES to be anywhere between 50,000W and 150,000W - This ensures the SMES receives more power than it uses and provides the ship with enough power to fully operate. Make sure to do the same for the two on the upper deck of engineering.

The principle is exactly the same for the planet-side SMES units. While they shouldn't be damaged, it's possible a stray explosion from one of the PFCs or Specialists damaged the wiring. Don't worry, just remember that SMES will only receive power from one side, every other side will output it. You can identify this side by the power terminal, just lead a cable from the reactors to this terminal and follow the steps and you'll be fine.

Hacking

Presently, disabling AI controls do nothing.

APCs

Wires

Name	Cutting	Mending	Pulsing
Power (2 wires)	Disables power. May shock!	Restores. May shock!	Disables power for 2 minutes. You must cut and mend the wire to restore power.
ID lock	Disable toggling the lock with an ID card.	Restores.	Unlocks APC interface for 30 seconds.
AI control	Disables AI control.	Restores.	Very briefly disables AI control.

Status window

Name	Status	Shows that
Lock	The APC is locked.	APC is locked.
	The APC is unlocked.	APC is unlocked.
Power	The APCs power has been shorted.	APC is not working.
	The APC is working properly!	APC is working.
AI control	The 'AI control allowed' light is off.	AI/borgs can't interact with APC.
	The 'AI control allowed' light is on.	AI/borgs can interact with APC.

Airlocks

Wires

Name	Cutting	Mending	Pulsing
Main power	Disables main power. May shock!	Restores. May shock!	Disables main power for 1 minute.
Backup power	Disables backup power. May shock!	Restores. May shock!	Disables backup power for 1 minute.
ID scan	Nothing.	Nothing.	Flashes lights on the door, as if someone without access tries to open it.
Bolts	Drops door bolts.	Nothing.	Drops door bolts if they are up. Raises them if they are down and door is powered.
Bolt lights	Disables bolt lights.	Enables bolt lights.	Toggles bolt wires.
Open	Nothing.	Nothing.	Opens the door if it either requires no access or if ID scan wire has been cut.
AI control	Disables AI control.	Restores AI control.	Very briefly disables AI control.
Shock	Electrifies the door.	De-electrifies the door.	Electrifies the door for 30 seconds.
Safety	Disables safety.	Enables safety.	Toggles safety.
Timing	Causes the door to close almost instantly after opening.	Restores.	Toggles door timing.

Status window

Name	Status	Shows that
Power	The test light is on.	Door is powered.
	The test light is off!	Door is not powered.
Bolts	The door bolts look up.	Door bolts are up.
	The door bolts have fallen!	Door bolts are down.
Bolt lights	The door bolt lights are on.	Door bolt lights are on.
	The door bolt lights are off!	Door bolt lights are off.
AI control	The 'AI control allowed' light is on.	AI can control the door and hasn't hacked it.
	The 'AI control allowed' light is off.	AI either hacked a door or can't control it.
Safety	The 'Check Wiring' light is on.	Door safety is off.
	The 'Check Wiring' light is off.	Door safety is on.
Timing	The 'Check Timing Mechanism' light is on.	Door timing is broken.
	The 'Check Timing Mechanism' light is off.	Door timing is normal.

Vendors

Wires

Name	Cutting	Mending	Pulsing
Contraband	Nothing.	Nothing.	Toggles illegal/rare goods availability on/off (shown by a green light).
Access	Rescinds access restriction (shown by a purple/yellow light).	Restores access restrictions.	Nothing.
Shock	Causes the machine to electrocute people (shown by an orange light).	Restores.	Electrifies the machine for 30 seconds.

Minor Repairs

So you're guarding the barricade at the FOB and a big red xeno rushes at it, swipes your turret and barricades and dies. Whilst it's good that it's dead, your turret and barricade are now damaged and enough swipes like that will knock both of them out of commission permanently. No worries, you're an engineer (I'm assuming you are if you're reading this guide), you can repair damages like that easily.

Barricades and Turrets

These are easy fixes and simply only require a blast from the blowtorch. Simply examine the structure you wish to repair and assess the damage and how many blasts it will take.

If the structure is heavily damaged, you need to use metal or plasteel sheets to patch it up before you use blowtorch.

If the structure is destroyed, then you will have to rebuild it from scratch. Destroyed barricades will yield some metal to help rebuild it with but it is always less than what it was built with.

Security Cameras

Screwdriver open the panel and use a pair of wirecutters to mend all the wires. Close the panel with the screwdriver if you want when done.

Light frames

Either remove the broken light with an empty, free hand and slot in a replacement bulb from a box of spare light bulbs. Or, simply use a Light Replacer to remove and replace the broken light in one swift action.

Airlocks

Open the panel with a screwdriver, mend all the broken wires with a pair of wirecutters and the door should begin operation. Unbolt the bolts and repair the APC as needed.

Windows

When windows get smashed to pieces, they will need to be repaired. Upon a window's destruction, it will fall into a number of shards equal to the number of sheets used to make it (and if it was a reinforced window - an equal number of rods). A blowtorch can be used to reshape the shards into sheets to make glass sheets, clicking the sheets whilst you have rods inhand will convert one sheet and rod into a reinforced window. You may then either use the sheet in hand to make a directional window, or use them on a window frame. At time of writing, there is not a way to repair damaged but undestroyed windows

Pro tip: do not repair windows on the planet. They will be damaged by xenos pretty easily, and block the firing lines of your fellow marines.